Monday, September 23, 2013

Prime & Fresh paint A Vehicle For Candyapple Red-colored Fresh paint

Painting a car can improve the value and also add a personal touch to the vehicle. When you undertake this project you will have to also take several things into consideration. The expenditure on the equipment can be expensive and the techniques will have to be practiced before applying paint to the car. If you are willing to undertake the investment, practice painting a car, and have the right equipment, this can become a way to make extra income.


Instructions


1. Tape off the car for painting. This is done in a couple of ways. Large surface areas such as the windshield, windows, light and bumpers should be taped off with the butcher's paper. To do this simply run the masking tape halfway across the top of the paper. Place this across the very top of the windshield. Tape the other three sides to the windshield. Tape off the trim. Follow this same process for all of the windows. To tape the lights cut a section of paper in the general shape of the light and attach to the light and tape off. Put the wheel cover on over the tires. They will fit over most tires.


2. Taping trim and smaller sections will require using only tape. If you are taping trim use the masking tape and cover the trim strip only. Try to tuck the tape behind the trim. Tape the door handles with the masking tape by covering them completely. Make sure that only the areas you want painted are visible. Check a couple of times in case you missed something.


3. Put on the gas mask. Pour the primer into the paint-gun canister. Hook the paint gun onto the canister and then attach it to the airline for the compressor. Turn on the compressor. Spray the car in even long strokes going back and forth using short bursts from the gun. This is done by pulling and releasing the trigger. This will eliminate the primer from running or dripping. Allow to dry for 24 to 48 hours depending on the humidity. Clean the paint canister by rinsing with water. Allow to dry. Clean the gun portion by holding the trigger until it is blowing clear air.


4. Put on the gas mask. Fill the canister with the paint. Paint the car with the paint gun. Start from the top of the car and work your way down using short bursts of paint and moving the gun in a straight line. Take your time. Too little is better than too much since it will run. Continue this process until the entire car is painted. Clean the gun and canister the same way you did in Step 3. Allow the car to dry for 24 to 48 hours depending on humidity.


5. Remove the tape after the car has dried. It should not be tacky. The paint should feel smooth to the touch. Be very careful when removing the tape. Do not rush, because this will cause you to remove some of the paint you just applied.


6. Buff the car with a car-buffing pad. This will bring out a deeper shine in the paint. Do not apply too much pressure because this will damage the fresh paint.


7. Wax the car when you are finished buffing. Remove the wax with a soft lint free cloth. Apply a second coat of wax and remove it. You might wish to add a third coat if you want, but it is not necessary.









Related posts



    Prepare, Prime and Paint a Wall (DIY)Painting can quickly and dramatically change the appearance of a room, an apartment or an entire home. It is task that is personally rewarding, inexpensive, an...
    Whitewall tires look classy but can be expensive--unless you paint your own.Depending on the make and model of your vehicle, whitewall tires, especially wide whitewall tires, can look extremely tr...
    A good option for adding color or renewing an old set of stairs is to paint them. When you paint a set of stairs you can restore the original color or use different colors for contrast. Learn pain...
    Changing the color in a room from dark to light will make the room seem larger and in some cases more cheery. It is possible that you have procrastinated because the task seems daunting. Painting...
    Paint Lexan PlasticLexan plastic is a very hard and virtually unbreakable type of plastic polymer used in the production of a variety of items including astronaut helmets, motorcycle and safety he...