The most common way to surface a pool is by using paint. There are a variety of colors, and it is a cost-effective way to surface or coat a pool. There are three different types of paint that are used to surface a pool: epoxy, chlorinated rubber base, and water-based acrylic.
Types of Pool Paint
Epoxy pool paint is primarily used on pools that are newly constructed or that have had previous coatings of epoxy paint. Epoxy is durable and usually lasts anywhere from seven to ten years. It stands up well to UV rays, cleaners, and various chemical treatments. Chlorinated rubber-based paint is not as expensive as epoxy paint, but it is not as durable either. While it only lasts about three to five years, it is easy to use and easy to apply. It comes in a variety of colors. Water-based acrylic paint is usable on any kind of surface. It is easy to use and is easy to clean up. Commercial pools that are painted regularly normally use this type of paint.
Common Problems With Pool Paint
Fading is a common problem with pool paint, and it cannot be stopped. Use a light acid wash to brighten up the paint on the pool. Clean the surface with a light mixture of muriatic acid and water. Rinse it well and then refill the pool.
If the water is dull and hazy and a white powdery substance is rubbing off on the hands or feet, the paint is in process of breaking down and becoming chalky. Correct this by adjusting the alkalinity of the pool. While 175 PPM is the target, alkalinity should go no lower than 150 PPM and no higher than 200 PPM. Do not use a harsh shock treatment, as this will also cause the paint to become chalky.
To prevent blistering or bubbles, apply the paint to a clean, dry surface. Do not apply coats of paint too thickly, as this too causes blisters in the paint. If the pool is in an area that receives direct sunlight, shade it to keep the paint from becoming too hot or too warm. Clean the pool on a regular basis to keep the paint from blistering. Do not apply paint during a hot season or during the hotter part of the day, as the temperature at the time of application will affect the paint. If the paint does blister, either repaint the pool or the areas that have blistered.
Related posts
After several years of use, pool owners are often faced with the decision of restore the appearance of the finish of the pool surface. With fiberglass pools, the choice is limited to painting. But...
Your swimming pool would look much better with a new coat of paint. But what do you do about reining in the cost of the paint to complete the job?ConsiderationsThe total cost of the paint is close...
Careful preparation of the surface will help paint adhere properly.Painting your house can be a big job that requires time and effort, as well as proper painting techniques, to ensure that the tas...
Before painting, check which type of paint is already on the surface.Before painting the inside or outside of your home, determine whether the original paint was oil-based or latex paint, because...
Your pool may need a fresh coat of paint.Over time, the paint on the walls of concrete and gunite in-ground pools begins to chip, flake and fade, which causes problems for the pool's filtering sys...
